Good day All,
Welcome back!!! we had a recent requirement to move a Blade from 1 Frame to another on a Linked Frame of 4 and following steps was performed
Pre-plan:
1. Note ILO IP details
2.If you have to create new Profile then all the NIC's VLAN information needs to be noted.
3.Blade to be verified if its using VC assigned NIC's,WWW N's or Server default and MAC address and WWW N's needs to be noted.
4.Need to make sure VLAN's been used in current Frame, same is already in palace on New frame which means need to verify Ethernet Networks for same VLAN in place.
4. SAN Fabric if present then need to make sure same is present in new frame we well.
Steps Performed:
Note:
Our Frames are old setup that is SAN connected to a MDS Fiber switch to 2 VC modules on Bay 3,4. For starters this setup is like a physical Server connected to a external Fabric switches just that its internal that's it.
Also the VC profile was setup to use Blade MAC and WWW N's.
1. Source Server was powered down
2. Existing Profile was unassigned
3. ILO IP was unchecked in old frame and assigned in new frame in OA
4. After the move , as the frames are linked assigned the existing profile pointing to new Blade location in the new Frame.
5.Before powering on network NIC's VLAN was changed so that all the NIC's use new Frame to upload or connectivity
6.After changing Server was powered on
7. NIC's MAC address for the blade didn't change and all the IP's etc was intact.
8.Blade had a Qlogic MEZ card attached to a MDS Fiber switch and WWW N's was intact when we moved to new Frame and no re-zoning was required.
9.Post validation was done.
Hopefully this helps someone and until next one you all have a good day!!!
Welcome back!!! we had a recent requirement to move a Blade from 1 Frame to another on a Linked Frame of 4 and following steps was performed
Pre-plan:
1. Note ILO IP details
2.If you have to create new Profile then all the NIC's VLAN information needs to be noted.
3.Blade to be verified if its using VC assigned NIC's,WWW N's or Server default and MAC address and WWW N's needs to be noted.
4.Need to make sure VLAN's been used in current Frame, same is already in palace on New frame which means need to verify Ethernet Networks for same VLAN in place.
4. SAN Fabric if present then need to make sure same is present in new frame we well.
Steps Performed:
Note:
Our Frames are old setup that is SAN connected to a MDS Fiber switch to 2 VC modules on Bay 3,4. For starters this setup is like a physical Server connected to a external Fabric switches just that its internal that's it.
Also the VC profile was setup to use Blade MAC and WWW N's.
1. Source Server was powered down
2. Existing Profile was unassigned
3. ILO IP was unchecked in old frame and assigned in new frame in OA
4. After the move , as the frames are linked assigned the existing profile pointing to new Blade location in the new Frame.
5.Before powering on network NIC's VLAN was changed so that all the NIC's use new Frame to upload or connectivity
6.After changing Server was powered on
7. NIC's MAC address for the blade didn't change and all the IP's etc was intact.
8.Blade had a Qlogic MEZ card attached to a MDS Fiber switch and WWW N's was intact when we moved to new Frame and no re-zoning was required.
9.Post validation was done.
Hopefully this helps someone and until next one you all have a good day!!!
No comments:
Post a Comment